Reassembling
To reassemble the AirCurve 11 VPAP Tx:
Hold the outlet connector with the seal pointing to the left and the clip pointing forward.
Make sure the outlet connector is correctly aligned and insert the outlet connector into the socket.
Check the outlet connector is inserted correctly.
Connect the air tubing firmly to the air outlet located on the rear of the device.
Open the humidifier tub and fill it with water up to the maximum water level mark.
If using the HumidAir 11 Standard water tub, use distilled water only
If using the HumidAir 11 Cleanable water tub, use drinking quality water (potable)
Close the humidifier tub and insert it into the side of the device.
Connect the free end of the air tubing firmly onto the assembled mask.
For further assistance, refer to Setting up the device.